Page 1 of 1

Disturbance clamp setup not conform

Posted: 05 Mar 2021, 15:06
by Evosonic
Hi at all,

after many years i want to use the radimation for measure disturbance power. TSF and setting are okay but there is something wrong implemented in the clamp movement settings. My problem is that i donĀ“t have the option to adjust the the stepsize in accordance with CISPR 16-2-2 (table 3 and 4) . The software done only lineare steps depending on numbers of steps over the whole distance, that is wrong. Can you fix this soon. Maybe if this test would be multiband i can fix it myself but i dont have the option or dont find it.

Re: Disturbance clamp setup not conform

Posted: 08 Mar 2021, 15:31
by Jeru
Hello,

I can give you a heads up that we are currently working on the multiband absorbing clamp functionality ;)
Using this functionality it will be possible to configure the clamp movement measurements to your requirements.

This functionality shall become available in a t.b.d future RadiMation release.

Jeru