RadiMation forum

Hi,

I've just installed 2016.1.6 and want to try next this function "Amplifier linearity".
As you wrote on 17th Dec. 2015 that the correct settings should be -> Forward power calibration method, so is it not pssible using this function in Net power calibration method?

Thanks

Hello John,

when will Version 2015.3.1 be released using this new feature?

thank you.

Regards
Juergen

Hello John,

thank you.
I think in January i will then upgrade to the new version and test this feature.

thank you.

Regards
Juergen

Hi John, thank you for your well described answering to my question. :) :) At the moment I use the amplifier protection as you know I've got an excel-file directly from AR where all the relevant data is in. e.g. 1dB, 3dB compression line, linearity line and so on. currently I've added the 1dB file i...

Hi Lüder,

thank you for answering.
I saw that you're from Basel.
Is it possible that I can contact you directly by phone or email?

give me feedback, thanks

Best Regards from Graz
Juergen

Hi, concerning the substitution test in 61000-4-3 and 4-6 is it necessary to check it manually(3.1 - 5.1dB) if the amplifier is saturated or not? In chapter 12 (Calibration) I found the following, see pic. calibration 61000-4-3.jpg So I assume Radimation uses the "final calibration result file" meth...

hi, I want to measure with the capacitive voltage probe according cispr 16-2-1 and therefore I want to know how should be the setup for this measurement? cispr 2-1 voltage probe method.jpg Do I have to do the setup as I've done it for the LISN-method like creating a new LISN (device driver) and afte...

Hi, I’ve doing the setup for the test 61000-4-6 with the net-power-method(see attached files) but I'm not sure if this is working correct (see attached file for the result window). e.g. the forward power is 17dBm this corresponds to approx. 1,6V (50 Ohm System) but in the calibration setup I put the...

Hi John,

thank you, but I've used Anechoic chamber.
Is it possible?

regards

is it possible modyfying an existing eut file with another limit line?
e.g. in the current eut file the range goes from 30 - 230 MHz and the limit is 40dbµV, but it should be 50dBµV.

is there a possibility to modify this?

Hi, I just used to measure with the van veen Loop antenna as described by joro. I do the measurement with each axis seperately(Schwarzbeck HXYZ 9170) but radimation always measured it three times (Location type: LISN Line1, 2, 3) and I don't know why because I set the Location type to "Current Senso...