Guide to make a new configurable device driver

Discussion and questions regarding the RadiMation device drivers that control the measurement equipment.
Post Reply
User avatar
sast
Posts: 168
Joined: 05 Sep 2012, 15:39
Contact:

Guide to make a new configurable device driver

Post by sast »

Despite the wide variety of supported device drivers you may still find that your device is not (yet) available in the device drivers list. In some cases it is possible to make a new configurable device driver untill RadiMation has added your device. This can be achieved by the following steps:

Click in the menu Configuration --> Configuration. Then open the tab Device Drivers and select your device type. In this particular example select 'Antennas' from the pull down menu. Now click the 'New' button and search for 'configurable antenna', as shown in the figure 1 below.
1new antennas search for.PNG
1new antennas search for.PNG (56.2 KiB) Viewed 4752 times
1 Device Drivers

Select the 'Configurable Antenna' and hit the 'New' button. Now you can enter the description (type) of your device driver (figure 2) and click 'Ok'.
2description.PNG
2description.PNG (12.8 KiB) Viewed 4752 times
2 Description

The configurable device driver is now added. Select it and click 'Edit' to configure the settings (figure 3).
3settings.PNG
3settings.PNG (48.25 KiB) Viewed 4752 times
3 Settings

Here you may enter the 'Brand' name if you like. On the right click the 'Advanced' button. It's important to enter the correct Start and Stop frequency and then click 'Ok' (figure 4).
4frequency.PNG
4frequency.PNG (11.83 KiB) Viewed 4752 times
4 Start and Stop Frequency

Now you are ready!
Post Reply