RadiMation forum

How can I determine the attenuation of a cable with RadiMation®

RadiMation® has attenuation measurement build in. It consist of 2 phases, the system calibration and the eut calibration. The system the measurements are part of a calibration so the EUT window must be closed before you can access the feature. You can reach the system calibration by:

Calibration
System Calibration
Attenuation / Gain

Then create a new EUT for the cable(s) you want to measure.

Calibration
E.U.T. Calibration
Attenuation / Gain

Select the create system calibration and run the test. More information can be found here

Additional information is stated in Chapter 12 of the manual under 'System Calibration' and 'Attenuation system calibration'.

See the page directly by this link to our wikipage: http://wiki.dare.nl/wiki/index.php/Chap ... alibration