New version: RadiMation version 2016.1.11

This forum contains news and upcoming events regarding RadiMation
Post Reply
User avatar
sast
Posts: 168
Joined: 05 Sep 2012, 15:39
Contact:

New version: RadiMation version 2016.1.11

Post by sast »

We have released an updated minor version of RadiMation software, which includes several new device drivers and some small fixes for problems that have been detected since the release of the 2016.1.10 version.
We strongly advise to test and verify (according to your quality system) this and each new version of RadiMation at for example a separate PC or laptop with your setup and with your measurement equipment, before you are going to use it for daily operation.

The following issues are fixed in this 2016.1.11 version (compared to the 2016.1.10 version):
  • #7008: Reflected power too high
  • #7279: End of Surge test is not correctly detected on a Teseq NSG3040
  • #7461: Unable to use formula option in AD converter
  • #7485: Driver Signal Generator Keysight 33522B
  • #7515: SRQ errors are generated using Tektronix TDS5034B
  • #7542: Driver Amplifier IFI S41-250
  • #7624: Driver Keysight Amplifier N4985A
  • #7631: Agilent Technologies N9038A Scanning Receiver: Device is not aligned error
  • #7638: Maximum selectable RBW for the Analyzer As Powermeter settings is 50 kHz
  • #7642: Agilent N9038A set RBW raised error Data out of range; the value 0 was clipped to the minimum value of 10
  • #7651: Wrong frequency range Teseq CBA 1G-1000
  • #7654: Configurable Amplifier custom frequency range is not retained
  • #7693: Device driver configuration of the RSS1006A (CTR1001S) field sensor
The complete list of release notes can be found on: http://wiki.dare.nl/wiki/index.php/Release_Notes_2016.1.

The new 2016.1.11 release of RadiMation can be downloaded from the DARE!! web-site: Image

We always advise to thoroughly test EACH new RadiMation software version to determine if it works correctly in your situation with your equipment, before you use it for daily measurements. This is even a requirement for all ISO 17025 accredited test-labs. To enable customers to validate new software versions before they implement that new software version, we even made it possible to install multiple versions of RadiMation side-by-side on a single PC.
Post Reply