This version 2021.2.3 has been validated by our internal software quality checks. We strongly advise to test and verify (according to your quality system) this and each new version of RadiMation at for example a separate PC or laptop with your setup and with your measurement equipment, before you are going to use it for daily operation.
Download
The new 2021.2.3 release of RadiMation can now be downloaded from the Raditeq web-site.
We always advise to thoroughly test each new RadiMation software version to determine if it works correctly in your situation with your equipment, before you use it for daily measurements. This is even a requirement for all ISO 17025 accredited test-labs. To enable customers to validate new software versions before they implement that new software version, we even made it possible to install multiple versions of RadiMation side-by-side on a single PC. It is of course also possible to perform this validation on for example a separate PC or laptop.
Known issues
- #9118: Ambient suppression in Multiband Emission GTEM causes that the GTEM correlation is not performed
New functionality
The following features are added to RadiMation 2021.2
- #2273: Multiband Conducted emission absorbing clamp.
- #5579: Stopping a sequence is almost impossible.
The following issues are fixed in this 2021.2.3 version (compared to the 2020.1.9 version):
- #9170: Some properties set in the polarGraph init function get reset when the graph is actually drawn.
- #11892: Before/After actions Pauze window does not close it self, or by clicking the OK button.
- #11851: Minimum absorbing clamp distance is 1 mm. This should be changed to 0mm.
- #11854: Final measurement stops after first final measurement if distance graph is selected.
- #11855: If the default graph configuration is set to logarithmic, a strange x-axis is shown for distance graph
- #11856: If distance unit is set to cm, the frequency too high errors are generated in the distance graph
- #11857: The unit configuration of the distance is not used in the graph x-axis
- #11858: Limit line in the distance graph is shown as a curved line. This should be a straight line in the distance graph.
The complete list of release notes can be found on: https://wiki.radimation.com/wiki/index. ... tes_2021.2 .