New Version: RadiMation version 2021.2.7

This forum contains news and upcoming events regarding RadiMation
Post Reply
Jeru
Posts: 38
Joined: 09 Jun 2020, 15:48

New Version: RadiMation version 2021.2.7

Post by Jeru »

We have released an updated version of the RadiMation software, which includes several improvements and fixes for problems that have been detected since the release of the 2021.2.3 version.
This version 2021.2.7 has been validated by our internal software quality checks. We strongly advise to test and verify (according to your quality system) this and each new version of RadiMation at for example a separate PC or laptop with your setup and with your measurement equipment, before you are going to use it for daily operation.

Download
The new 2021.2.7 release of RadiMation can now be downloaded from the Raditeq web-site. Image

We always advise to thoroughly test each new RadiMation software version to determine if it works correctly in your situation with your equipment, before you use it for daily measurements. This is even a requirement for all ISO 17025 accredited test-labs. To enable customers to validate new software versions before they implement that new software version, we even made it possible to install multiple versions of RadiMation side-by-side on a single PC. It is of course also possible to perform this validation on for example a separate PC or laptop.

Known issues
  • #9118: Ambient suppression in Multiband Emission GTEM causes that the GTEM correlation is not performed
If you have a problem or question, please do not hesitate to report it to us, so we can continue to improve RadiMation.

New functionality
The following features are added to RadiMation 2021.2
  • #2273: Multiband Conducted emission absorbing clamp.
  • #5579: Stopping a sequence is almost impossible.
Fixed issues
The following issues are fixed in this 2021.2.7 version (compared to the 2021.2.3 version):
  • #11795: Add ability to measure electrical fields of ~ +1000 V/m using a RadiSense
  • #11806: RIGOL device driver is measuring too high AVG and QP detector values
  • #11846: Measured differences between RadiMation and PMM software when Testing CE/RE
  • #11962: Distance unit text is missing in generated reports
  • #11965: ErrorReport: "Antenna distance incorrect after upgrade to new version (2021-1-6 -> 2021-2-3)"
  • #11988: ErrorReport: "Unable to see cable under test descripton"
  • #12040: Slow start of RadiMation Pulsed Immunity test
  • #12050: ErrorReport: "Cannot find positioner"
  • #12064: ErrorReport: fault "System._ComObject"
  • #12078: Absorbing clamp Maturo FCU: Function not implemented error
  • #12084: Correction file with Frequency unit in kHz only shows half of the graph
  • #12087: Opening test data older than 2021.2.1 results in missing distance data
  • #12088: ErrorReport: "RI with rot pos, 1 step, 120 degrees".
If you have specific questions regarding on of the above items, please contact us at radimation-support@raditeq.com

The complete list of release notes can be found on: https://wiki.radimation.com/wiki/index. ... tes_2021.2 .
Post Reply