This version 2023.1.6 has been validated by our internal software quality checks. We strongly advise to test and verify (according to your quality system) this and each new version of RadiMation at for example a separate PC or laptop with your setup and with your measurement equipment, before you are going to use it for daily operation.
Download
The new 2023.1.6 release of RadiMation can now be downloaded from the Raditeq website.
We always advise to thoroughly test each new RadiMation software version to determine if it works correctly in your situation with your equipment, before you use it for daily measurements. This is even a requirement for all ISO 17025 accredited test-labs. To enable customers to validate new software versions before they implement that new software version, we even made it possible to install multiple versions of RadiMation side-by-side on a single PC. It is of course also possible to perform this validation on for example a separate PC or laptop.
Known issues
- #9118: Ambient suppression in Multiband Emission GTEM causes that the GTEM correlation is not performed
Fixed issues
The following issues are fixed in this 2023.1.6 version (compared to the 2023.1.5 version):
- #13580: EP600 times out if the binary data returned contains a new line character
- #13666: Provide a more generic 'attenuator' and 'pulse limiter' device driver
- #13674: EMI Schaffner SCR3502 measures high peak values while measuring in the noise
- #13692: Invalid message when removing input from TSF
- #13709: TDEMI Cancel don't work in remote control
- #13744: Logging mode is not supported by this powermeter.
- #13748: Singleband Conducted immunity fixed voltage checks for a CI mill cal data document
- #13756: Include check in firmware update if RadiLink is connected to the external power supply
- #13768: Fixed step count stepper, only tests the first and last frequency of a band
The complete list of release notes can be found on: https://wiki.radimation.com/wiki/index. ... tes_2023.1 .