More correction files for coupler

Discussions and question about the general functionality of RadiMation
Post Reply
heutink
Posts: 59
Joined: 22 Sep 2016, 11:23

More correction files for coupler

Post by heutink » 07 Mar 2019, 17:03

Normally you can add only one correction file for the FWD or REV path of a coupler. Is it possible to add more than one correction file in the coupler path. Reason: between coupler and RF power meter we have several RF components, like coax cables and power combiners. We want to correct for all these RF components without making one overall correction file.

tjsc
Posts: 10
Joined: 18 Jun 2018, 12:27

Re: More correction files for coupler

Post by tjsc » 29 Mar 2019, 15:00

When you need to correct for devices that do not have a device driver or that do not have the capability to add a correction file you can add these as a cable in your test-site at the place where they are inserted in the signal path. We have called it cable but you can use this to correct for anything you insert in your path that you need to correct for. First let's define a cable. To make a cable that you can add to your test-site later on go to "Configuration"/"Configuration" in the upper menu.

Go to "Cables" and make a new cable. Select "Configurable Cable"
Give the cable a name that has meaning to what it is for. This is helpful for later troubleshooting and helps to visualize your path.
Cables.png
Cables.png (30.84 KiB) Viewed 904 times
After creating the cable you need to attach a correction file to it. A correction file can be made by clicking the menu item "File/New/Correction" This will open a screen where you can edit your correction file and save it. When the correction file is made, add it by going to the settings of the specific cable and select a correction file via the selection box below.
Cables2.png
Cables2.png (19.35 KiB) Viewed 904 times
Now that you have made a cable and added a correction file to it you can add this to your test-site to correct for transfer loss in your cables/attenuators etc.

Select the place where you need to add the correction in your path. To add a cable to your Test-Site open the Test-Site and go to "Cables". Here you can choose a place in the path to add the "Cable" to.
Cable3.png
Cable3.png (23.17 KiB) Viewed 904 times
Now you have added a extra correction in your path. As you can see there are multiple points to insert your correction.

This should give you the info to correct your devices correctly.
Attachments
Cables.png
Cables.png (30.84 KiB) Viewed 905 times
Cable3.png
Cable3.png (23.17 KiB) Viewed 905 times
Cables2.png
Cables2.png (22.79 KiB) Viewed 907 times

ReginaldT
Posts: 1
Joined: 10 Oct 2019, 10:42

Re: More correction files for coupler

Post by ReginaldT » 09 Jan 2020, 15:02

Is this the right procedure to set any device correctly?

Post Reply