RadiMation forum

Hello,

by testing BCI Closed loop, the calculation of the forward power in case the required current cannot be achieved seems to work unpropperly. By testing 100mA with a calibration of 200mA, and a k=4 following seems to happen:

1) Current is not reached;
2) K=4 is applied to the power used for 200mA calibration. In this case i expect, that first the software compares the calibration file with the required current. If the calibration current is not equal to the required current, then a calculation of the needed calibration power assuming a linear system should be done.
3) On the power calculated in Step 2 K=4 should be applied.

Can you check if this is possible? Feel free to cotact me for more information or if you have some questions...

Greetz Marius

Thank you for reporting this issue. We have created a new item for this problem with the reference #5218: BCI Closed loop is generating overtesting

Could you please provide us with the following information:
- Send us a copy of the used TSF file
- Which version of RadiMation is used
- Which exact device drivers are used during the calibration (e.g. which jig device driver is used etc.)
- Which exact device drivers are used during the test (e.g. which jig device driver is used etc.)