Tolerance setting
Posted: 21 Nov 2011, 16:58
Hi all,
I would like to know exactly how is treated the Tolerance setting when an immunity with field-probe-current-voltage is performed.
For example: when performing a BCI test at 100dBuA closed loop (with current reading), if the value of the tolerance is 0.2dB, the software will regulate the siggen level in order to read 99.8 - 100.2 dBuA.
But when an irradiated immunity is performed, V/m should be taken into account instead of dBuA. How is performed the conversion dB --> V/m? That is, how much is 0.2dB of tolerance when dealing with V/m?
This question is asked from every customer.
Thanks a lot!
I would like to know exactly how is treated the Tolerance setting when an immunity with field-probe-current-voltage is performed.
For example: when performing a BCI test at 100dBuA closed loop (with current reading), if the value of the tolerance is 0.2dB, the software will regulate the siggen level in order to read 99.8 - 100.2 dBuA.
But when an irradiated immunity is performed, V/m should be taken into account instead of dBuA. How is performed the conversion dB --> V/m? That is, how much is 0.2dB of tolerance when dealing with V/m?
This question is asked from every customer.
Thanks a lot!