Radilog error on multiband radiated emissions measurements
Posted: 13 Jan 2017, 21:54
Performing a multiband radiated emission measurement in one run on several sub-bands (4) with different parameters (EUROCAE ED-14). Each sub-band takes 4001 points. During the run sometimes a "Radilog error" and "out of memory" error occurs. It looks that this error is related to the parameter "points" setting of the receiver (R&S ESU-40).
Standard the setting of this parameter is around 620 within Radimation. We are using "points" settings of 4001 to 5001. Reason: better resolution of the measured frequency peaks. Could it be that there is too much data handling, because of the high "points" setting of the receiver. So Yes, what is the maximum "points" setting Radimation can handle.
Standard the setting of this parameter is around 620 within Radimation. We are using "points" settings of 4001 to 5001. Reason: better resolution of the measured frequency peaks. Could it be that there is too much data handling, because of the high "points" setting of the receiver. So Yes, what is the maximum "points" setting Radimation can handle.