Visibility of receiver settings in Receiver Window
Posted: 01 Dec 2017, 13:26
When re-opening a performed multiband test for CE or RE the fields: VBW, Sweep Time and Measure Time are not visible in the Receiver Window.
I understood in the past that this is problematic because of the different RBW, VBW and Sweep Time settings for each frequency range in a Multi-band measurement.
However, is there a simple way to make these settings visible in the plots. Lets say, by clicking on the frequency range of interest the fields in the Receiver window will be filled with the correct reciever settings.
I understood in the past that this is problematic because of the different RBW, VBW and Sweep Time settings for each frequency range in a Multi-band measurement.
However, is there a simple way to make these settings visible in the plots. Lets say, by clicking on the frequency range of interest the fields in the Receiver window will be filled with the correct reciever settings.