Compare a test result against another measurement

Discussion and questions regarding the Radiated Emission and Conducted Emission modules of RadiMation.
Post Reply
james
Posts: 4
Joined: 26 May 2020, 10:55

Compare a test result against another measurement

Post by james »

Could you please explain how to compare a measurement against another previously executed measurement?
I want to compare the data before and after the calibration of my analyser.
roge
Posts: 38
Joined: 01 Oct 2018, 12:17

Re: Compare a test result against another measurement

Post by roge »

What you can do is the following

1. Open the reference measurement test result
2. Choose "Graphs"
3. Choose "Export"
Choose Export.PNG
Choose Export.PNG (40.85 KiB) Viewed 2613 times
4. Choose the line to use as a reference line.
Select the graphline.PNG
Select the graphline.PNG (26.65 KiB) Viewed 2613 times
5. Check "Reference Line" on the left side.
6. Make sure to rename the file and choose a different colour.
7. And save the file as a LLF file by clicking "Export".
Save as reference line.PNG
Save as reference line.PNG (18.46 KiB) Viewed 2613 times
Then, when a new test is started, this exported reference line can be used by adding it as a limit line.

Note: for reference lines no max hold is done, so all measured values are visible, this seems odd but it is still usable to compare against other measurements.
Result.PNG
Result.PNG (50.37 KiB) Viewed 2613 times
Post Reply