Radiated Emission with Gauss TDEMI X6, "realtime scanning"
Posted: 21 Oct 2021, 09:44
Hello guys,
currently we are doing the radiated emission measurement with a Gauss TDEMI X6 receiver and their measuring software (EMI64k).
In the future we want to perform this measurement with Radimation.
I have done all relevant settings now and the measurement itself is working fine, but i recognized the following:
1. Measuring with EMI64k:
The measurement is done in spectro mode from 30MHz-685MHz and then from 685MHz-1000MHz. The measurement in each step (30-685MHz) is done in "realtime" with max hold during the rotation of the turntable. So at the end I have nearly at all turntable angle a measurement result. --> very good
2. Measuring with Radimation
Attached is a screenshot from the TSF. So the measurement procedure is same as in EMI64k. BUT Radimation is only updating the results each ~4s (not in "realtime"). Means at the end I have only for all eg. 30° a measuring result and the angle diagram is looking very rough.
anybody an idea how to solve this issue?
Thanks and best regards
currently we are doing the radiated emission measurement with a Gauss TDEMI X6 receiver and their measuring software (EMI64k).
In the future we want to perform this measurement with Radimation.
I have done all relevant settings now and the measurement itself is working fine, but i recognized the following:
1. Measuring with EMI64k:
The measurement is done in spectro mode from 30MHz-685MHz and then from 685MHz-1000MHz. The measurement in each step (30-685MHz) is done in "realtime" with max hold during the rotation of the turntable. So at the end I have nearly at all turntable angle a measurement result. --> very good
2. Measuring with Radimation
Attached is a screenshot from the TSF. So the measurement procedure is same as in EMI64k. BUT Radimation is only updating the results each ~4s (not in "realtime"). Means at the end I have only for all eg. 30° a measuring result and the angle diagram is looking very rough.
anybody an idea how to solve this issue?
Thanks and best regards