Page 1 of 1
modify limit line in eut file
Posted: 12 Feb 2015, 16:39
by radiuser
is it possible modyfying an existing eut file with another limit line?
e.g. in the current eut file the range goes from 30 - 230 MHz and the limit is 40dbµV, but it should be 50dBµV.
is there a possibility to modify this?
Re: modify limit line in eut file
Posted: 12 Feb 2015, 16:53
by joro
Hello RadiUser,
Yes, it is possible to change the limitline file after the measurement is performed.
Are you using a multiband emission? Just click on the 'Limit Lines' button, remove the old limit line, and select the new limit line file.
The graph will automatically be updated with the new limit line.
Also the Pass/Fail status of the detected peaks will be updated with the new limitline.
Best regards,
John
Re: modify limit line in eut file
Posted: 12 Feb 2015, 17:05
by radiuser
Hi John,
thank you, but I've used Anechoic chamber.
Is it possible?
regards
Re: modify limit line in eut file
Posted: 12 Feb 2015, 22:13
by joro
Hello Radiuser,
I'm sorry, but in the older 'Anechoic Chamber' test, it is not possible to change limitlines afterwards.
That is one of the reasons that we suggest to use the multiband emission tests. The multiband emission tests are more powerful to perform these type of changes, like changing the limitline afterwards.
With best regards,
John