This version 2025.1.8 has been validated by our internal software quality checks. We strongly advise to test and verify (according to your quality system) this and each new version of RadiMation at for example a separate PC or laptop with your setup and with your measurement equipment, before you are going to use it for daily operation.
Download
The new 2025.1.8 release of RadiMation can now be downloaded from the Raditeq website.
We always advise to thoroughly test each new RadiMation software version to determine if it works correctly in your situation with your equipment, before you use it for daily measurements. This is even a requirement for all ISO 17025 accredited test-labs. To enable customers to validate new software versions before they implement that new software version, we even made it possible to install multiple versions of RadiMation side-by-side on a single PC. It is of course also possible to perform this validation on for example a separate PC or laptop.
Fixed issues
The following issues are fixed in this 2025.1.8 version (compared to the 2025.1.x version):
- #14334: BLN modulation is now available in RadiMation
- #14335: AWGN modulation is now available in RadiMation
- #14933: Driver: Audivo Pecos 8.2
- #15120: AWGN and BLN modulation is now possible with R&S SMCV100B Generators
- #15322: PECOS 8 device driver
- #16350: Save correction is shown when creating a new correction file.
- #16664: Drivers: R&S FSH-8
- #16766: NX-series now selects correct IEC phase mode command based on the connected coupling device
- #16773: SMF100A carrier level can be set to -30 dBm
- #16786: Fix NX series Surge generator coupling mode selection
- #16794: NX -Series surge now raises errors when invalid resistance and capacitance values are selected for a DCD automated coupler
- #16795: NX series allow testing power and data line coupling device testing in the same TSF
- #16806: Axos 5 now sends te correct command to switch the SHV output for EFT.
- #16814: Axos 5 now sends te correct command to switch the SHV output for Surge.
- #16820: NX series SURGE: Add coupling NX 5 and 7 bsp-1-300-16
- #16844: Stepsize of reverberation chamber calibration can now be configured
- #16846: Reverberation test windows now show correct title
The complete list of release notes can be found on: http://wiki.dare.nl/wiki/index.php/Release_Notes_2025.1.